ADS 507165, Installation, Operation And Maintenance Manual, Page: 379 / 535

9-16 ADS Manual
Digital Outputs
The (with an ADS XIO) can provide the event status for
to up to two third-party systems or devices via digital (relay) output
signals. To configure the monitor to properly deliver the signals to
these third-party devices, you must configure the ADS
Q start
XML
software with the specific event about which you want to relay the
current status information.
Connecting a Third-Party Device to a Digital
Output on the XIO
Perform the following procedure to connect each third-party device
(up to two) to a digital output terminal on the ADS XIO:
Note: Make sure external power is available, but not
turned on , to the monitor before connecting the signal
wiring. If it is not available, you cannot complete testing,
which may require return visits by the owner
representative and/or electrician or instrument technician
for wiring problems.
1. Configure the Digital Ouput 1 (or 2 ) component of the XIO
Device through Q start
XML
to indicate the event with which you
want to associate each digital output. Refer to Chapter 4 ,
Configuration and Activation , for instructions on selecting this
parameter in Q start
XML
.