KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA00xx73xxxxx
│
212
–
Heating and cooling
: For operating a two-wire or four-wire system used to heat or cool a
room. Switching between heating and cooling takes place using a central switch (two-wire
system) or is carried out manually and / or automatically via the single room temperature
controller (four-wire system).
–
Heating and cooling
with an additional stage: In addition to the heating and cooling
functions, one additional stage each with an autonomous controller type can be
programmed.
Note
This parameter is only available if the "Device function" parameter is set on
"Single device" or "Master device".
10.24.3 General - Operating mode after reset
Options:
Comfort
Standby
Eco mode
Frost/heat protection
After a reset the device will run in the operating mode after a restart until a new operating mode
is set as the result of device operation or by communication objects, as the case may be. This
operating mode should be defined during the planning phase. An improperly defined operating
mode can result in a loss of comfort or increased energy consumption.
–
Comfort
: If the room temperature is not automatically lowered and the room is therefore
controlled independent of its use.
–
Standby
: If the room is controlled automatically, e.g. by a presence detector, as a function of
its use.
–
Eco mode
: If the room is controlled automatically or manually as a function of its use.
–
Frost/heat protection
: If only the building protection function is necessary in the room after a
reset.
Note
This parameter is only available if the "Device function" parameter is set on
"Single device" or "Master device".
