HVC
‐
PD
E
‐
Bus
Charger
Installation
Guide
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022 Page
74
of
146
Remove the protection cover
1. Remove the protection plate (A) by loosening the screws (B) (4x).
2. Put the protection plate and screws in a safe location as it will be installed again later on.
5.7.1. Connect the DC power cables
1. Cut the wires of the DC power cable to the correct lengths to reach the connectors. Do
not make the wire routing too tight, or too loose.
2. Strip the insulation on the required length specified by the used lug from the end of the
wire (B).
3. Attach cable lug (A) at the end of the wires.
4. Remove the nuts and washers (C) from the bolts (M12) of connector block (D) and (E).
5. Insert the DC+ wire (marked by red heat-shrink) with the nuts and washers onto the bolts
of pin 1 of the connector block (D).
6. Insert the DC- wire with the nuts and washers onto the bolts of pin 1 of the connector
block (E).
7. Tighten the nuts (C) with a tightening torque of 22 ft-lb.