29
3D Systems, Inc
.
NOTE: If the print file requires PLA material and ABS material is
installed, the printer will prompt you to change the cartridge(s) .
Select
CHANGE CARTRIDGE
and refer to the section titled
Replacing
A Material Cartridge
for instructions about replacing a cartridge .
NOTE: If the print file requires ABS material and PLA material is
installed, the printer will prompt you to change the cartridge(s) .
Select
CHANGE CARTRIDGE
and refer to the section titled
Replacing
A Material Cartridge
for instructions about replacing a cartridge .
NOTE: If there is not enough material to complete the print but you
want to use up the remaining material, select the
checkmark
to
continue printing .
NOTE: If the file was built with color(s) that are not installed, the
printer will assign a color from one of the installed cartridges that
match the material type . Select the
checkmark
to continue .
4 . Apply two thin layers of Cube Glue to the center of the print pad . Select the
checkmark
to continue .
NOTE: Ensure that the area where glue is applied is larger than the
dimensions of the base of your creation .
NOTE: For best results, allow the glue to dry before printing .
Summary of Contents for CUBE
Page 1: ...Cube Personal 3D Printer User Guide Original Instructions 3rd Generation ...
Page 59: ...55 3D Systems Inc Information Select Information A to view the printer status A ...
Page 72: ...68 3D Systems Inc Change Views Select Change Views and then select the camera viewing angle ...
Page 78: ...74 3D Systems Inc 1 Select an item from My Shelf 2 Select Print Now ...
