103
3D Systems, Inc
.
TEST PRINT
Test print allows you to print the same welcome message that is printed during the initial setup of the printer . The print is very useful for
determining if the gap between the left print jet and the print pad is correct .
1 . Select
TEST PRINT
.
2 . Select
.
NOTE: If the color built into the test print does not match a color of
one of the installed cartridges, the printer will assign an installed
cartridge color to the test print .
3 . Apply two thin layers of Cube Glue to the print pad . Select the checkmark to
continue .
NOTE: Apply enough glue to cover a square area of 5” (15 cm) .
NOTE: For best results, allow the glue to dry before printing .
Summary of Contents for CUBE
Page 1: ...Cube Personal 3D Printer User Guide Original Instructions 3rd Generation ...
Page 59: ...55 3D Systems Inc Information Select Information A to view the printer status A ...
Page 72: ...68 3D Systems Inc Change Views Select Change Views and then select the camera viewing angle ...
Page 78: ...74 3D Systems Inc 1 Select an item from My Shelf 2 Select Print Now ...
