3Com S7902E, Configuration Manual

Page: 1634 / 2621

1-13
To do… Use the command… Remarks
Associate the service instance
with a VPLS instance
xconnect vsi vsi-name
[ access-mode { ethernet |
vlan } ]
Required
By default, a service instance is
not associated with any VPLS
instance.
Support for keywords hub ,
spoke , and access-mode
depends on the device model.
Configuring VPLS Attributes
After configuring a VPLS instance, you can configure some other attributes for the instance.
Configuring Other VPLS Attributes
Follow these steps to configure other VPLS attributes:
To do… Use the command… Remarks
Enter system view system-view —
Enter VSI view vsi vsi-name —
Specify the encapsulation type
of the VPLS instance encapsulation { bgp-vpls |
ethernet | vlan }
Optional
vlan by default, which
corresponds to the VSI PW
encapsulation type of tagged.
Set the description of the VPLS
instance
description text
Optional
No description set by default
Shut down the VPLS service of
the VPLS instance
shutdown
Optional
Enabled by default
Specify a tunneling policy for
the VPLS instance
tnl-policy tunnel-policy-name
Optional
By default, a VPLS instance
uses the default tunneling
policy.
Displaying and Maintaining VPLS
Displaying and maintaining VPLS
To do… Use the command… Remarks
Display the VPLS information in
the BGP routing table
display bgp vpls { all | group
[ group-name ] | peer
[ [ ip-address ] verbose ] |
route-distinguisher
route-distinguisher [ site-id
site-id [ label-offset
label-offset ] ] }
Available in any view