3Com S7902E, Configuration Manual

Page: 1714 / 2621

1-65
Out-Label : 1024
In-Interface : Vlan-interface1
Out-Interface : Vlan-interface2
LspIndex : 4097
Tunnel ID : 0x22001
LsrType : Transit
Bypass In Use : In Use
BypassTunnel : Tunnel Index[Tunnel5], InnerLabel[1024]
Mpls-Mtu : 1500
No : 2
IngressLsrID : 2.2.2.2
LocalLspID : 1
Tunnel-Interface : Tunnel5
Fec : 3.3.3.3/32
Nexthop : 3.2.1.2
In-Label : NULL
Out-Label : 1024
In-Interface : ----------
Out-Interface : Vlan-interface4
LspIndex : 4098
Tunnel ID : 0x22002
LsrType : Ingress
Bypass In Use : Not Exists
BypassTunnel : Tunnel Index[---]
Mpls-Mtu : 1500
# Set the FRR polling timer to five seconds on PLR.
[SwitchB] mpls
[SwitchB-mpls] mpls te timer fast-reroute 5
[SwitchB-mpls] quit
# Bring the protected outgoing interface up on PLR.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] undo shutdown
%Sep 7 09:01:31 2004 SwitchB IFNET/5/UPDOWN:Line protocol on the interface Vlan-interface2
turns into UP state
Perform the
display interface tunnel 4
command on Switch A to identify the state of the primary LSP.
You can find that the tunnel interface is up.
About 5 seconds later, perform the
display mpls lsp verbose
command on Switch B. You can find that
Tunnel5 is still bound with interface VLAN-interface 2 and is unused.
7) Create a static route for routing MPLS TE tunnel traffic
[SwitchA] ip route-static 4.1.1.2 24 tunnel 4 preference 1
Perform the
display ip routing-table
command on Switch A. You can find a static route entry with
Tunnel4 as the outgoing interface.