3Com S7902E, Configuration Manual

Page: 676 / 2621

1-43
Configuring OSPF Network Management
After trap generation is enabled for OSPF, OSPF generates traps to report important events. Traps fall
into the following levels:
z
Level-3, for fault traps
z
Level-4, for alarm traps
z
Level-5, for normal but important traps
z
Level-6, for notification traps
The generated traps are sent to the Information Center of the device. The output rules of the traps,
namely, whether to output the traps and the output direction, are determined according to the
Information Center configuration. (For Information Center configuration, refer to "Information Center
Configuration" in the System Volume .)
Follow these steps to configure OSPF network management:
To do… Use the command… Remarks
Enter system view system-view
—
Bind OSPF MIB to an
OSPF process
ospf mib-binding process-id
Optional
The OSPF process with the
smallest
process-id is bound
with OSPF MIB by default.
Enable OSPF trap
generation
snmp-agent trap enable ospf
[ process-id ] [ ifauthfail | ifcfgerror |
ifrxbadpkt | ifstatechange |
iftxretransmit |
lsdbapproachoverflow |
lsdboverflow | maxagelsa |
nbrstatechange | originatelsa |
vifcfgerror | virifauthfail |
virifrxbadpkt | virifstatechange |
viriftxretransmit |
virnbrstatechange ] *
Optional
Enabled by default
Enabling Message Logging
Follow these steps to enable message logging:
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance instance-name ] *
—
Enable message
logging
enable log [ config | error | state ]
Required
Not enabled by default.