3Com S7902E, Configuration Manual

Page: 1456 / 2621

1-22
To do… Use the command… Remarks
Configure the LDP transport
address
mpls ldp transport-address
{
ip-address
|
interface
}
Optional
MPLS LSR ID of the LSR by
default
If you configure an LDP transport address by specifying an IP address, the specified IP address must
be the IP address of an interface on the device. Otherwise, the LDP sessions cannot be established.
Configuring Remote LDP Session Parameters
Configure a remote session transport address by specifying an IP address.
Follow these steps to configure remote LDP session parameters:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a remote peer entity and
enter MPLS LDP remote peer
view
mpls ldp remote-peer
remote
-
peer-name
Required
Configure the remote peer IP
address
remote-ip ip-address
Required
Configure LDP to advertise
prefix-based labels through a
remote session
prefix-label advertise
Optional
By default, LDP does not
advertise prefix-based labels
through a remote session.
Set the targeted Hello timer
mpls ldp timer hello-hold
value
Optional
45 seconds by default
Set the targeted Keepalive
timer
mpls ldp timer
keepalive-hold value
Optional
45 seconds by default
Configure the transport
address
mpls ldp transport-address
ip-address
Optional
MPLS LSR ID of the LSR by
default
By default, LDP does not advertise any prefix-based label mapping message through a remote session,
and remote sessions are used only to transfer messages for L2VPNs. For applications of remote
sessions, refer to information about Martini MPLS L2VPN configuration in
MPLS L2VPN Configuration
of the
MPLS Volume
.