3Com S7902E, Configuration Manual

Page: 477 / 2621

1-21
To do… Use the command… Remarks
Clear the statistics of IPv6 and
ICMPv6 packets (for distributed
devices)
reset ipv6 statistics [ slot
slot-number ]
Available in user view
Clear the statistics of IPv6 and
ICMPv6 packets (for distributed
IRF devices)
reset ipv6 statistics [ chassis
chassis-number slot slot-number ]
Available in user view
Clear all IPv6 TCP connection
statistics
reset tcp ipv6 statistics Available in user view
Clear the statistics of all IPv6 UDP
packets
reset udp ipv6 statistics Available in user view
IPv6 Configuration Example
Network requirements
z
Host, Switch A and Switch B are directly connected through Ethernet ports. Add the Ethernet ports
into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify the
connectivity between them.
z
The aggregatable global unicast addresses of VLAN-interface 2 and VLAN-interface 1 on Switch A
are 3001::1/64 and 2001::1/64 respectively.
z
The aggregatable global unicast address of VLAN-interface 2 on Switch B is 3001::2/64, and a
route to Host is available.
z
IPv6 is enabled for Host to automatically get an IPv6 address through IPv6 NDP, and a route to
Switch B is available.
Figure 1-6 Network diagram for IPv6 address configuration
The VLAN interfaces have been created on the switch.
Configuration procedure
z
Configure Switch A
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Specify an aggregatable global unicast address for VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address 3001::1/64
[SwitchA-Vlan-interface2] quit