3Com S7902E, Configuration Manual

Page: 604 / 2621

1-6
To do… Use the command… Remarks
Enter system view
system-view
––
Enable a RIP process and
enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
Required
Not enabled by default
Enable RIP on the interface
attached to the specified
network
network network-address
Required
Disabled by default
z
If you make some RIP configurations in interface view before enabling RIP, those configurations
will take effect after RIP is enabled.
z
RIP runs only on the interfaces residing on the specified networks. Therefore, you need to specify
the network after enabling RIP to validate RIP on a specific interface.
z
You can enable RIP on all interfaces using the command network 0.0.0.0.
z
If a physical interface is attached to multiple networks, you cannot advertise these networks in
different RIP processes.
Configuring the interface behavior
Follow these steps to configure the interface behavior:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
––
Disable an or all interfaces from
sending routing updates (the
interfaces can still receive
updates)
silent-interface
{ interface-type
interface-number | all }
Optional
All interfaces can send routing
updates by default.
Return to system view quit —
Enter interface view
interface interface-type
interface-number
—
Enable the interface to receive
RIP messages
rip input
Optional
Enabled by default
Enable the interface to send
RIP messages
rip output
Optional
Enabled by default
Configuring a RIP version
You can configure a RIP version in RIP or interface view.