P. 80
nanobox | tangerine User Manual
Dec 11, 2023
Manually Create or Remove Slices
When you configure slices manually, you use the Split and Join menu options to add and
remove splits. The manual process may also be used to refine the results after you use auto
scan or slice to grid.
1.
On the Waveform screen for the slicer pad touch the menu item with the three dots
“. . .”. This will display the Waveform Slicing menu.
2.
Use touch gestures to move the waveform so the fixed cursor position (the vertical
white line) is at the position where you want to add another slice point.
3.
Touch Split to create a slice point. The slice point is shown as a white horizontal line
with a small square near the bottom.
4.
To removes a slice, use touch gestures to move the waveform so the fixed cursor
position (the vertical white line) is on or near a slice point that you want to remove,
then touch Join to remove the slice point. You can have as many or as few slices as
you want.
Use Auto Scan to Create Slices:
When you use auto scan, the tangerine uses an internal algorithm to decide where to place
the splits. You can control the sensitivity of the algorithm.
1.
From the Waveform screen for the slicer pad, touch the menu item with the three
dots “. . .”. This will display the Waveform Slicing menu.
2.
Touch Scan and then use a control knob to select a Threshold percentage for the
sensitivity of the scan. The lower the threshold, the higher the number of slices that
will be created.
Touch OK when you are ready to scan. (You can touch anyplace outside of the
Threshold field to cancel the scan.) The tangerine will detect and create slice points
in the file automatically.
