P. 64
nanobox | tangerine User Manual
Dec 11, 2023
EDITING PAD CONFIGURATION PARAMETERS
CONFIGURATION
SCREEN
MACRO SCREEN
Open the Pad Configuration Screen
From the Pad Macro screen, touch Config. The pad’s
Configuration Parameters screen opens.
The first several parameters correspond to the Level, Pitch,
Filter Cut-off, Resonance, and Panning, all of which appear in
the Pad Macro, and Mixer screens.
Three small squares appear to the right of each parameter to
indicate if the parameter is being modulated. For details on
modulation, see “Modulating Pad and Effects Parameters” on
page 104.
The following table describes the first five Pad Configuration
parameters.
Parameter
Description
Level
Volume level of the current pad. Range: -96dB to +12dB. Corresponds to
the Level in the Pad Macro and Mixer screens.
Pitch
Pitch shift over a range of +/- 2 octaves, not quantized to semitones.
Changing the Pitch affects the sample playback speed. Corresponds to
the Level in the Pad Macro screen.
Filter
Sets the filter cut-off frequency and filter type simultaneously.
Values from 0 to 100.0% set the cut-off for a high-pass filter.
Values from 0 to -100.0% set the cut-off for a low-pass filter.
Corresponds to the Filte parameter in the Pad Macro screen.
Res
Emphasizes frequencies at and around the cut-off frequency. As
resonance approaches 100%, the filter comes close to oscillating at the
cut-off frequency. Corresponds to the Res parameter in the Pad Macro
screen.
Pan
Pans the pad audio from the left to right channels by controlling ratio of
left channel volume to right channel. At -100.0% the pad is panned fully to
the left. At +100.0%, the pad is panned fully to the right. At 0-.0%, the pad
is “centered” with equal levels in both channels. Corresponds to the Pan
parameter in the Mixer screen.
