P. 74
nanobox | tangerine User Manual
Dec 11, 2023
Set Up Loops in Sample Pad Mode
You can edit the pad’s loop points numerically in the Position parameters screen or
visually in the Waveform screen.
Edit Loop Points in the Position Parameters Screen
1.
Open the Pad Position Parameters screen and make sure you are about to edit the
correct pad’s loop parameters.
2.
Edit the Loop Start and Loop End parameters, using the top knob to select each
parameter, and the bottom knob to change its value.
3.
Listen to how the pad loop changes while you edit the loop points. Play the pad over
MIDI or by touching the play button at the top of the screen.
Note:
The Loop End parameter defines the position of the last sample in the loop, not the
loop length. So, unlike the Start and Length parameters, if you change the Loop Start after
setting the Loop End, you don’t have to adjust the Loop End.
