Zeiss S100, Инструкция по эксплуатации

Страница: 13 / 278

Version 9.0
G-30-1781-en
Page 13
S100 / OPMI pico Safety measures
(e.g. IEC 60950 for data processing equipment).
In addition,, all configurations must comply with the standards for medical
systems (see IEC 60601-1, section 16; in some countries IEC 60601-1-1 may
still be valid). Anyone connecting additional equipment to medical electrical
devices is a system configurer and as such responsible for compliance of the
system with the normative requirements for systems.
Please note that local legislation takes priority over the requirements of the
above-mentioned standards. If you have any questions, contact your local
dealer or ZEISS Service.
Optics and light • Never look into a light source or the sun with the binocular tube,
the objective lens or an eyepiece.
• Never look directly into the light source, e.g. the microscope objective lens
or light guide, as this may cause phototoxic injury to the eye.
• Adjust the brightness on the suspension system. Start with the lowest
brightness and then slowly increase the brightness until the necessary
level is reached but do not exceed the permissible level.
• With increasing age of the light source, the actual illumination intensity
delivered at the setting in question decreases (this is a normal property of
the system).
Requirements for operation
Prior to the very first use
A ZEISS Service representative or an expert authorized by ZEISS will install the
system. Please make sure that the following requirements continue to be met
for further operation: