Zeiss S100, Инструкция по эксплуатации

Страница: 102 / 278

Preparations for use S100 / OPMI pico
Version 9.0
Page 102 G-30-1781-en
Mounting the documentation accessories on the MORA interface with
a lateral output port
Prerequisite

The MORA interface with lateral port for documentation accessories has
been mounted on the surgical microscope.
The method described below can also be used for other accessories.
The operating principle of the accessories is described in the relevant
Instructions for Use.
Attaching the
documentation
accessories
• Loosen the knurled ring (2). An arrow with the labeling "open" is located
on the shaft next to the knurled ring (2).
• Remove the dust cover (3) and store it in a safe place.
• Slide the accessories (4) in the image exit port holding fixture.
The mount of the image output is equipped with guide brackets.
The accessory (4) has corresponding grooves.
• Carefully turn the accessory module until the guide projections fit into the
grooves,
• and slide the accessory in the mount as far as it will go.
• Screw the knurled ring (2) onto accessory module (3).
• Firmly tighten the knurled ring (2).
If the accessory is mounted with the connector pointing vertically
upwards, the image of the connected camera will be displayed with a 90°
rotation.
• To avoid this, you can mount the accessory rotated by 90° so that the
connector (incl. camera) points horizontally to the back.
• Note the effect of the annular diaphragm (1) swung into the beam path.
Fig. 53: Mounting the
documentation accessories
on the MORA interface
with a lateral output port
2 4 3 1