Zeiss opmi lumera 700, Инструкция по эксплуатации

Страница: 20 / 236

2 Safety notes Instructions for Use
OPMI LUMERA 700 2.6 Requirements for operation
20 / 236 G-30-1673-en - 14.0 - 2018-07-12
u
Make sure that the device is connected to an electrical outlet
with a proper protective ground conductor.
u
Determine the supply voltage at the installation site and set the
voltage of the device in accordance with the installation site's
supply voltage.
u
Make sure the device is connected using the provided power
cable.
Hazards arising from connecting the device to an IT network
The following safety measures should be observed in order to
prevent injuries or damage:
u
Check to make sure that the requirements for connecting the
device to an IT network are met. [
}
90]
Hazards arising from condensation of air humidity
Moving the device from a cold environment (T < 10 °C) to a warm
one may cause air humidity to condense.
u
If you move the device from a cold environment to a warm
one, wait at least one hour before switching the device on to
allow it to reach the environment's ambient temperature.
2.6.2 Before every use
Hazards arising from phototoxicity
To prevent phototoxic damage to the patient's eye:
u
Check the light source for visible damage.
u
Check the filter setting.
u
Switch off the light source for light guides that are not being
used and attach them to the mount provided.
Hazards arising from attached accessories and components
The following safety measures should be observed in order to
prevent injuries or damage:
u
Never exceed the device's maximum permitted weight load.
u
Always route cables so that they do not hinder the user.
u
Never cover any ventilation openings. Doing so can cause the
device to overheat and fail.
u
Never attempt to forcefully connect any electrical connectors. If
a connection cannot be made, check to make sure the plug fits
the socket. If any of the connectors are damaged, have the
ZEISS Service team or an authorized service representative
repair them.