Zeiss opmi lumera 700, Инструкция по эксплуатации

Страница: 155 / 236

Instructions for Use 7 Operation
OPMI LUMERA 700 7.5 Daily operation
G-30-1673-en - 14.0 - 2018-07-12 155 / 236
7. If you selected mixed light, use the arrow buttons to modify
the mix ratio.
8. To temporarily save the settings: tap the button.
9. To save the settings as start values to the user profile: tap the
button.
7.5.1.2 Checking the main and auxiliary light sources
The main and auxiliary light sources [ } 81] provide light to the SCI
illumination system and the auxiliary illumination system. Before
each use, check each light source to make sure it is functioning
properly. The device detects which light source is installed and
displays the appropriate menu.
CAUTION!
Risk of infection caused by xenon lamp rupture!
Lamp fragments may unnoticeably contaminate sterile areas of the
device.
u
Never exceed the lamp's maximum service life of 500 hours.
u
When the remaining service life reaches 5 hours, replace the
lamp and reset the service hour counter.
NOTE
Light source failure caused by ageing of the lamp!
As the light source ages, the actual illumination intensity decreases.
The intensity of the light sources may fluctuate, or the light sources
may fail.
u
Before each use, check each light source to make sure it is
functioning properly.
u
LED light source: If the fault signal is illuminated, the light
source is defective, and the light intensity is 50%. Inform ZEISS
Service.
u
Xenon light source: If the fault signal is illuminated, the xenon
lamp is defective, and the backup xenon lamp is in use. Replace
the lamp.
u
Halogen light source: If the fault signal is illuminated, the
halogen lamp is defective, and the backup halogen lamp is in
use. Replace the lamp.
u
Keep a backup lamp or an OR illuminator ready at hand.
Action 1. Return to the main menu.
2. Tap the [Light] menu button.
ð
The "Light" menu will appear.