Zeiss opmi lumera 700, Инструкция по эксплуатации

Страница: 185 / 236

Instructions for Use 10 Troubleshooting
OPMI LUMERA 700 10.3 Faults (without messages)
G-30-1673-en - 14.0 - 2018-07-12 185 / 236
Message / Fault Cause Remedy
System error. The error can be
acknowledged. If the error recurs,
please contact your ZEISS service
representative. Unknown software or
hardware error.
u
Acknowledge the error
message.
u
If the message appears again,
contact ZEISS Service.
10.3 Faults (without messages)
10.3.1 Device faults
Fault Cause Remedy
No electrical function in device The power plug is not plugged
in.
u
Connect the power plug. [
}
92]
The stand power switch is not
switched on.
u
Check to make sure the power
switch is illuminated green. If it
is not: press the power switch.
[
}
124]
Automatic circuit breaker in
the stand power switch is
being triggered.
u
Press the power switch. [ } 124]
u
If the automatic circuit breaker
is triggered again, notify ZEISS
Service.
There is a power supply failure.
u
Contact the in-house electrician.
Illumination on the surgical
microscope is out of service. Suspension arm is in the park
position.
u
Move suspension arm into the
working position. To do this,
pull the suspension arm
downwards. [
} 120]
The light source is not
switched on.
u
Press the configured buttons on
the handgrip or the 14-function
foot control panel.
Halogen light source: halogen
lamp failure.
u
Switch halogen lamps. [
}
192]
Superlux Eye light source:
xenon lamp is defective.
u
Swivel the backup xenon lamp
in. [
} 193]
Superlux Eye light source:
xenon lamp and backup xenon
lamp are defective.
u
Change the Superlux Eye light
source lamp module. [
}
194]
Superlux Eye light source: lamp
module is not making contact.
u
Push the lamp module in as far
as it will go. [
}
194]
Light guide is not properly
inserted on the microscope.
u
Push the light guide in as far as
it will go.
Stand electronics failure.
u
Illuminate the OP field with an
OP lamp.
u
Contact ZEISS Service.