Instructions for Use
10 Troubleshooting
OPMI LUMERA 700
10.4 Troubleshooting work
G-30-1673-en - 14.0 - 2018-07-12
193 / 236
10.4.4 Swiveling the backup xenon lamp into position and
resetting the remaining service hours
2
4
3
1
Figure 80: Swiveling the backup xenon lamp into position
1
Lamp housing
2
Lamp module
3
[Backup xenon lamp] switch
4
[Open lamp module] button
CAUTION!
Risk of injury caused by lamp rupture!
Lamp rupture may lead to jamming of the lamp module and failure
of the electronics modules.
u
The lamp module may be changed only by appropriately
trained personnel.
u
Before opening the lamp housing: move the device to a
position in which falling particles cannot put the patient or user
at risk.
u
If the lamp module is blocked or illumination is no longer
operable, the device may not be used any longer. Contact ZEISS
Service.
Prerequisite
þ
The power switch is off.
Action
1. Press the [Open lamp module] button.
ð
The lamp module will eject partially.
2. Pull out the lamp module as far as it will go.
3. Swivel the second xenon lamp (backup) into position. To do
this, rotate the [Backup xenon lamp] switch clockwise 180°
until it snaps into place.
ð
The red segment in the [Backup xenon lamp] switch will
appear.
4. Push the lamp module all the way back into the lamp housing.
5. Turn on the device at the power switch.
ð
The red segment in the [Backup xenon lamp] switch will
illuminate.
Содержание opmi lumera 700
