Zeiss opmi lumera 700, Инструкция по эксплуатации

Страница: 184 / 236

10 Troubleshooting Instructions for Use
OPMI LUMERA 700 10.2 Faults (with messages)
184 / 236 G-30-1673-en - 14.0 - 2018-07-12
ð
If no USB storage device is connected, the following error
message will appear: "Error - USB storage medium not
found."
10.2 Faults (with messages)
Message / Fault Cause Remedy
Pairing could not be performed
successfully. Several foot control
panels were detected. Multiple foot control panels
are nearby.
u
Restart the pairing process.
Pairing could not be performed
successfully. No foot control panel
was detected. The 14-function foot control
panel was not in a vertical
position and in the immediate
vicinity of the device.
u
Place the 14-function foot
control panel in a vertical
position in the immediate
vicinity of the device (less than
1m away) and restart the
pairing process. In the event of
malfunction, you can always use
the 14-function wireless foot
control panel with a cable. Keep
the cable in the vicinity of the
suspension system for this case!
XY coupling error. The error can be
acknowledged. If the error impairs
your work, please switch to manual
mode and contact your ZEISS service
representative. Hardware error in motor
electronics
Software error, inadmissible
status of motor control
u
If the error impairs your work:
Activate manual mode.
Light source error. The error can be
acknowledged. If the error impairs
your work, please switch to manual
mode and contact your ZEISS service
representative. Malfunction of light intensity
setting
u
If the error impairs your work:
Activate manual mode. [
} 184]
Zoom error. The error can be
acknowledged. If the error impairs
your work, please switch to manual
mode and contact your ZEISS service
representative. Jammed hardware
u
If the error impairs your work:
Activate manual mode. [
}
184]
Focus error. The error can be
acknowledged. If the error impairs
your work, please switch to manual
mode and contact your ZEISS service
representative. Focus system motor is jammed
u
If the error impairs your work:
Activate manual mode. [
}
184]
Error during system start. Please
reboot the system, making sure that
no function buttons are pressed
during the booting process. A button was pressed during
system start.
u
Restart the system. Make sure
not to press any buttons during
this process.