23-4
IM DL350-01EN
Network (Network)
Environment Settings (Preference)
Logic Settings (Logic)
Logic Channel Display Format (Numerical Format)
Choose whether to display the logic waveform values in the numeric monitor as binary (Bit) or hexadecimal (Hex)
values.
Bit Order (Bit Order)
• Cursor Read Order (Cursor)
Choose the order that you want to read the bit data from logic input signals in.
• 1->8: Bit 1 to bit 8
• 8->1: Bit 8 to bit 1
• Bit Data Display Order (Waveform)
Choose the order that you want to display the bit data from logic input signals in.
• 1->8: Bit 1 to bit 8
• 8->1: Bit 8 to bit 1
Terminal Setup (Terminal)
Enabling or Disabling the Remote High Edge (STOP) Signal (Remote Stop)
Select whether to enable (ON) the high edge (STOP) in the external start/stop remote signal or disable (OFF).
Trigger Output Signal (Trigger Out)
Select the type of signal to transmit from the trigger output terminal from the following options.
• Normal (Normal)
A falling signal is transmitted when a trigger occurs.
• Pulse (Pulse)
A pulse signal is transmitted when a trigger occurs. You can set the pulse width.
• Sample Pulse (Sample Pulse)
A pulse signal is transmitted at regular intervals when waveform acquisition is started. You can set the pulse
rate.
• Start/Stop (Start/Stop)
A high level signal is transmitted during waveform acquisition, and a low level signal is transmitted otherwise.
Pulse Width (Pulse Width)
When you set the trigger output signal type to Pulse, you can set the pulse width to 1 ms, 50 ms, 100 ms, or 500
ms.
Pulse Rate (Pulse Rate)
If you set the type of trigger output signal to sample pulse, set the pulse rate in the range of 5 Hz to 200 kHz (in
1-2-5 steps).
23 Other Features
