5.6.5.3
Operating mode per channel
Select via
‘Channel’
the channel select via
‘Operating’
the operating mode. The fol-
lowing operating modes are supported:
n
Not parameterized: Channel is deactivated
n
Chapter 5.6.6.1 ‘Count continuously’ on page 115
n
Chapter 5.6.6.2 ‘Count once’ on page 116
n
Chapter 5.6.6.3 ‘Count Periodically’ on page 119
n
Chapter 5.7 ‘Frequency measurement’ on page 128
n
Chapter 5.8 ‘Pulse width modulation - PWM’ on page 137
Depending on the selected operating mode default values are loaded and shown in an
additional register.
5.6.5.4
Counter
Default values and structure of this dialog box depend on the selected
‘Operating mode’
.
Parameter overview
Operating parameters
Description
Assignment
Main count direction
n
None
No restriction of the counting range
n
Up:
Restricts the up-counting range. The counter starts
from 0 or
load value
, counts in positive direction up to
the declaration
end value
-1 and then jumps back to
load value
at the next positive transducer pulse.
n
Down:
Restricts the down-counting range. The counter
starts from the declared
start value
or
load value
in
negative direction, counts to 1 and then jumps to
start
value
at the next negative encoder pulse. Function is
disable with
count continuously
.
n
None
Gate function
n
Cancel count:
The count starts when the gate opens
and resumes at the
load value
when the gate opens
again.
n
Stop count:
The count is interrupted when the gate
closes and resumed at the last actual counter value
when the gate opens again.
Chapter 5.6.7.2 ‘Gate function’ on page 122
Abort count process
Start value
End value
Start value
with counting direction backward.
End value
with main counting direction forward.
Range of values: 2...2147483647 (2
31
-1)
2147483647 (2
31
-1)
Parameter hardware con-
figuration
Parameter hardware con-
figuration
VIPA System SLIO
Deployment I/O periphery
Counting > Parametrization
HB300 | CPU | 013-CCF0R00 | en | 16-40
111
