Important:
To power off, always press the power button first. Wait until the lights on the user
interface stop blinking, to allow the fuser to finish cooling. Move the main power switch to the
off position.
Circuit Breaker Switch
The Circuit Breaker Switch located at the rear of the press. Initially check to make sure this switch is
set to
On
when the press is shipped.
Main Power Switch
The Main Power Switch located inside the Center Front Door.
Note:
Switching off the Main Power also shuts off the Main Power Status LED.
Tip:
Before switching off the press, ensure that it is not in Power Saver Mode.
This switch is used mainly by the Xerox Service Representative when servicing the press. In rare
troubleshooting situations, you may be directed to power off the press with this switch.
Power Button
The power button is located on the right side of the Control Panel. Use this button to power
ON
or
OFF
the press.
31