After replacing the filter, contact the system administrator. The administrator must log into
administrator mode and reset the High Frequency Service Item (HFSI) counter for this CRU to zero
(0).
Caution:
Make sure the press is powered off before performing this procedure.
1. At the back of the press, locate the suction filter cover on the lower panel.
2. Us the Torx driver to remove the screw on the right side of the cover by turning the screw
counterclockwise.
3. Pull out and remove the suction filter cover.
4. Grasp the handle of the filter box and pull straight out.
5. Remove the suction filter from the box.
6. Place the new suction filter into the box and push the filter box in until it stops and is flush with
the press.
7. Place the cover onto the filter box area.
a.
Make sure to first insert the left two tabs of the cover into the left side of the box area.
b.
Then push the entire cover flush to the press.
263