• Front Blower: Increase the blower speed by one setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. If a multifeed occurs again, for the Rear Lead Blower and Front Blower, increase
the blower speed by one setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 2c and 2d twice.
3. If using paper that is coated on one side only, or if multifeeds continue, do the
following.
a. Make the following blower adjustments:
• Air Knife Blower: No change.
• Rear Lead Blower: Change the setting to the preset value, then decrease
the speed by one setting.
• Front Blower: Change the setting to the preset value, then decrease the
speed by one setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. If a multifeed occurs again, for the Rear Lead Blower and Front Blower, decrease
the blower speed by one setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 3c and 3d twice.
4. If the problem is not resolved, contact your Xerox representative.
366