Page: 70
SmartPad LCD
™
© 2008 Xantech Corporation
RS232 Port Default Settings
Use this configuration when controlling a
single
RS232 device
from the
SPLCD
.
To change
Baud Rate, Data Bits, Stop Bits
or
Parity
settings, click on the corresponding pull-down and select
the desired setting per manufacturer’s specification for the device to be controlled via RS232. Default settings
for all are shown above in
Figure 51.
If controlling a
Xantech XDT Tuner
or
XMUSIC Server
, select the
appropriate
Driver
from the
pull-down
, when configuring the associated
Port
.
NOTE:
If controlling a
Xantech XDT Tuner
or
XMUSIC Server
, use a
Null Modem Cable
(Part No. 05913560).
RS232 Port Router Settings
Use this configuration when controlling
multiple
RS232 (or RS422) devices
(up to eight) from the
SPLCD
using
the
RS2321X8 Router
. See:
RS2321X8 Router Installation Instructions
for complete instructions.
1.
In the
Router Block
, select (check mark)
Xantech RS232 Router Enable
.
2.
To have the
RS2321X8
always return to a
specific port
(default) select (check mark)
Router’s Default
Port Enabled
and select the appropriate
Port
from the
Default Router Port pull-down
.
3.
To set the
individual
Router Ports
to the appropriate
Protocol
, using the
Router Port pull-down
, select
each
Port
individually
, (Port1, Port 2, Port 3, etc.) and set the
Baud Rate, Data Bits, Stop Bits
and
Parity
settings for
each device
by
Port,
per the manufacturer’s specification for the device connected to the
selected
RS2321X8 Port
.
4.
If controlling a
Xantech XDT Tuner
or
XMUSIC Server
, select the appropriate
Driver
from the
pull-down
,
when configuring the associated
Port
. (i.e. Port 1 = XDT, Port 2 = Xantech Music Server.)