Page: 32
SmartPad LCD
™
© 2008 Xantech Corporation
With the preceding steps complete, all sources added using the
AutoBuild Wizard
will have been placed into
the
SPLCD Project
in the
SPLCD System Window
. Click each of the
Source Buttons
and review the
Function Button layout
for each
source
. The buttons should all be
labeled
and have
IR
and/or
RS232
Commands
associated with each button. The programmed commands will appear in the
Macro Command
List
.
The Source/Function layouts should be ready to go, but if there are functions that are not required, functions
that need to be added, or additional programming that is required, (Macro Sequences, Trigger Commands, etc)
see the
Table of Contents
in this Manual for reference to the sections that will guide you through those steps.
If you are satisfied with the results of the AutoBuild Wizard as is, proceed to Sections:
Testing Commands
Placed on the Virtual SPLCD
and
Transferring the Project
.
10.
The
AutoBuild Completed! Window
will
appear and setup is complete for this
device. Click
Finish
.
11.
In the
Do You Want To Run The
AutoBuild Wizard Again Window,
Click
Yes
to add more devices. Click
No
to
Finish. If
Yes
, repeat
Steps 1-10
until all
devices have been added using the
AutoBuild Wizard.