Page: 68
SmartPad LCD
™
© 2008 Xantech Corporation
Input
When
Input
is selected in the
Line Input Role Block
and a 5 to 30V DC signal is present on the
Status
Terminal
on the rear of the
SPLCD
, the following event/actions can be triggered:
1.
The
Status LED
on the
SPLCD
Front Panel will turn ON [Requires
LED Track
to be selected, (check
mark)].
2.
Initiate a
Sense Trigger Macro
(if one is associated to the
System Window/Sense Tab/ON Button
).
3.
Utilize
Intelligent Power Management
(if selected at:
System Window/Sense Tab/Intelligent Power
Management
).
NOTE:
Items
1&2
or
1&3
may be programmed to occur simultaneously.
Output
When
Output
is selected in the
Line Input Role Block
, the
Status Terminal
becomes a switchable12V DC
Output. When the
Internal Command:
Set Line Status/ON
is placed under a
GTL
and that button is pressed,
the
Status Terminal
outputs
12V DC
. When the
Internal Command: Set Line Status/OFF
is placed under a
GTL
and that button is pressed, the
Status Terminal
outputs
0V DC
. This can be utilized to control an external
device via a 12V trigger when an appropriately configured GTL is pressed (i.e. Control a Projection Screen, a
Lift, Drapes or an amplifier with a 12V DC Control Input).
Note:
The
Status Output
is rated at 15mA maximum.
BACKLIGHT SETTINGS
This sets the
LCD Backlight
to stay ON for a specified amount of time after the display is last touched. The
Backlight
can be set to stay ON from
1-30 seconds
in
1 second increments
,
1-30 minutes
in
1 minute
increments
or
Always ON
.
NOTE:
The internal
IR receiver
is
disabled
whenever the
Backlight
is ON to avoid interference. Therefore if
Always ON
is selected, the IR Receiver will not be active.
DISPLAY ORIENTATION
The LCD Display needs to be configured for the proper viewing angle according to the position it will be
installed with regard to the user. (
Figure 50
)
Up
Select this setting if the
SPLCD
will be installed at a height
equal to or above
the user’s
eye level
. (
IR Sensor
on the
right
side,
Rear Panel
in
normal
orientation.)
Down
Select this setting if the
SPLCD
will be installed at a height
equal to or below
the user’s
eye level
. (
IR Sensor
on the
left
side,
Rear Panel
upside down
. If the SPLCD is not oriented as described, the graphics will appear
upside down.)