Wood-mizer LT15WB D17, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 80 / 88

Sawmill Alignment
Blade Guide Deflection
5
5-16 1510doc071918 Sawmill Alignment
1. Adjust the blade guide arm out to 1/2" (13 mm) from fully open.
2. Adjust the blade guide arm in all the way toward the other blade guide.
3. Use the outside top and bottom screws to adjust the arm up until the slide pad touches the saw
head brace tube. Tighten the jam nuts.
NOTE: When adjusting the blade guide arm screws, be careful not to tighten
the screws too much or put the arm in a bind. Operate the blade guide arm to
ensure the arm moves easily in and out.
See Figure 5-19. With the blade guide arm still all the way in toward the other blade guide,
tighten all the side screws until they touch the arm. Back the screws off 1/4 turn and tighten the
jam nuts.
4. Measure the distance between the blade guide arm and back edge of the blade. Adjust the
appropriate side screws on the blade guide arm housing so the arm is measures the same dis-
tance from the blade at both ends of the arm.
5. To move the blade guide end of the arm toward the front of the sawmill, loosen jam nuts on the
front inside screw and the rear outside screw. Turn the screws counterclockwise one full turn and
tighten the jam nuts. Loosen the jam nuts on the front outside screw and the rear inside screw.
Turn the screws clockwise until they touch the arm, back off 1/4” turn, and tighten the jam nuts.
6. To move the blade guide end of the arm toward the rear of the sawmill, loosen jam nuts on the
front outside screw and the rear inside screw. Turn the screws counterclockwise one full turn and
tighten the jam nuts. Loosen the jam nuts on the front inside screw and the rear outside screw.
Turn the screws clockwise until they touch the arm, back off 1/4” turn, and tighten the jam nuts.
Blade Guide Deflection
Perform the following steps to achieve proper blade deflection with the blade guides.
FIG. 5-19
Blade Guide Arm Parallel to Blade
Adjust side screws to
change arm angle
150036B