Wood-mizer LT15WB D17, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 49 / 88

Setup & Operation
Water Lube Operation
Setup & Operation doc071918 2-16
2
See Figure 2-6.
Not all types of wood require the use of the Water Lube System. When it is needed, use just enough
water to keep the blade clean. This saves water, and lowers the risk of staining the boards with
water. Usual flow will be 1-2 gallons (3.8-7.6 liters) per hour.
Before removing the blade, engage the blade. Let the blade spin with water running on it for about 15
seconds to clean the blade of sap buildup. Wipe the blade dry with a rag before storing or sharpen-
ing.
For further lubrication benefits, add one 12oz. (0.35L) bottle of Wood-Mizer Lube Additive to 5 gal-
lons (18.9 liters) of water. Wood-Mizer Lube Additive enables some difficult timbers to be cut by sig-
nificantly reducing resin buildup on the blade, heat buildup, wavy cuts, and blade noise. This
biodegradable and environmentally-friendly pre-mix includes a water softener additive to work with
hard water.
WARNING! Use ONLY water and Wood-Mizer Lube Additive with the water lube
accessory. Never use flammable fuels or liquids such as diesel fuel. If these types
of liquids are necessary to clean the blade, remove it and clean with a rag. Failure
to follow this can damage the equipment and may result in serious injury or death.
If you are sawing in freezing temperatures, remove the water lube bottle from the sawmill when done
sawing and store it in a warm place. Blow any remaining water from the water lube hose.
FIG. 2-6
FIG. 2-6
150203-2
Turn valve
counterclockwise
to open. Use shutoff
valve under the engine
to control water flow
Turn shutoff valve
counterclockwise to open;
Clockwise to close
Turn valve counterclockwise
to open; Clockwise to close
3H0129