Sawmill Alignment
Blade Wheel Alignment
Sawmill Alignment
1510doc071918
5-11
5
See Figure 5-12.
Use the vertical adjustment screws to adjust the drive-side blade wheel.
To tilt the wheel down, loosen the top adjustment screw one quarter turn. Loosen the jam nut on
the bottom adjustment screw and tighten the screw. Tighten the top and bottom jam nuts.
To tilt the wheel up, loosen the bottom adjustment screw one quarter turn. Loosen the jam nut on
the top adjustment screw and tighten the screw. Tighten the top and bottom jam nuts.
5.
Recheck the vertical tilt of the drive-side blade wheel with the blade guide alignment tool. Read-
just the blade wheel as necessary until the front and rear of the tool are the same distance from
the bed rail (within 1/16" [1.5 mm]).
6.
Remove the tool from the blade and reattach it near the outer blade guide assembly.
7.
Measure from the tool to the bed rail at both ends of the tool. If the measurements at the front
and rear ends of the tool differ by more than 1/16" (1.5 mm), adjust the vertical tilt of the idle-side
blade wheel.
FIG. 5-12
150210-14
Adjust vertical adjustment screws
down to tilt drive-side blade wheel up;
Adjust screws up to tilt wheel down
Blade Guide
Alignment Tool
Содержание LT15WB D17
