Wood-mizer LT15WB D17, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 30 / 88

Safety & General Information
Dust Extractor Specifications
1
1-16 doc071918 Safety & General Information
1.10 Dust Extractor Specifications
See Table 1-1. Specifications of the dust extractors used on the resaw for each saw head are listed
below.
1
IMPORTANT! The dust extractor hoses must be grounded or made
with materials not accumulating electrostatic charge.
CAUTION! Always turn on the dust extractor before starting the
machine
IMPORTANT! The total value of hand-arm vibration the operator may
be exposed to does not exceed 2.5 m/s
2
. The highest root mean
square value of weighted acceleration to which the whole operator’s
body is subjected does not exceed 0.5 m/s
2
.
2. The figures quoted are emission levels and are not necessarily safe working levels. Whilst there is a correlation between
the emission and exposure levels, this cannot be used reliably to determine whether or not further precautions are
required. Factors that influence the actual level of exposure of the workforce include the characteristics of the work
room and the other sources of noise etc. i.e. the number of machines and other adjacent processes. Also the
permissible exposure level can vary from country to country. This information, however, will enable the user of the machine
to make a better evaluation of the hazard and risk.
Airflow
1200 m
3
/h
3937ft
3
/h
Inlet diameter 100 mm (5.9”)
Motor power 1.5 kW
Number of sacks 1 pc
Sack capacity
0,25 m
3
(8.8 ft)
3
Weight 110 kg (242.5 lb)
Pressure drop
1,5 kPa (0.22 psi)
1
1
The pressure drop between the inlet of the capture device and
the connection to the CADES should be maximum 1,5 kPa
(for the nominal air flow rate). If the pressure drop exceeds
1.5 kPa the machine might not be compatible with conventional
CADES.
Recommended conveying air
velocity in the duct
20 m/s
65.6 ft/s
TABLE 1-1
1. External chip and dust extraction equipment with fixed installations are dealt with in EN
12779:2016-04.
!
!