Wood-mizer LT15WB D17, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 71 / 88

Sawmill Alignment
Blade Guide Flange Spacing
Sawmill Alignment 1510doc071918 5-7
5
NOTE: Once the blade guides have been adjusted, any cutting variances are
most likely caused by the blade.
See Blade Handbook, Form #600.
Blade Guide Flange Spacing
Each blade guide must be adjusted so the roller flange is the correct distance from the back edge
of the blade. If the flange is too close to or too far from the blade, the sawmill will not cut accu-
rately.
HINT: When adjusting blade guide spacing, loosen the top set screw and one
side set screw only. This will ensure horizontal and vertical tilt adjustments are
maintained when the adjustment screws are retightened.
1. Measure the distance between the flange on the outer blade guide roller to the back edge of the
blade. This distance should measure 1/8" (3.0 mm). Adjust the roller back or forward if neces-
sary.
See Figure 5-8. Loosen the top and one side screw shown. Tap the blade guide forward or back-
ward until properly positioned. Retighten the screws and jam nuts.
2. Measure the distance between the flange on the inner blade guide roller to the back edge of the
blade. This distance should measure 1/16" (1.5 mm). Adjust the roller back or forward if neces-
sary.
Side Support Alignment
Logs and boards are clamped against the side supports when sawing. The sides supports must
be square to the bed to ensure square lumber.
1. Place a flat board across the bed rails. Swing a side support up so that it is vertical.
2. Pull back at the top of the support to eliminate slack as if a log were being clamped against it.
FIG. 5-8
1/16” (Inner Blade Guide)
1/8” (Outer Blade Guide)
Loosen top and
one side adjustment
screw
3H0802-6