Wood-mizer LT15WB D17, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 51 / 88

Setup & Operation
Transporting the Sawmill
Setup & Operation doc071918 2-18
2
See Figure 2-8.
CAUTION! Adjust the saw head up just far enough so it will clear the sides of your
truck bed when loaded.
NOTE: For most pickup trucks, a minimum of 18” (460mm) between the blade and
bed frame cross members should be adequate. Do not adjust the saw head so
high that the sawmill will tip easily while being loaded.
2. Move the carriage to one end of the mill.
3. Rotate and release the lock pin closest to the end of the mill.
CAUTION! Be sure the lock pin engages the hole in the bed frame to secure the
saw carriage in place. The other lock pin remains in the operation position.
4. Remove the tailgate from your truck to eliminate the possibility of damage and/or injury,
5. Position the bed of the truck at the end of the frame opposite the carriage .
WARNING! Keep all persons out of the area between the frame rails while loading
and unloading the sawmill. Failure to follow this may result in serious injury or
death.
WARNING! Do not lift the sawmill onto the truck using ropes, cables, or chains,
etc.; the sawmill can easily rotate and tip over when lifted. Failure to follow this
may result in serious injury or death.
6. Position two people (for lifting) about two feet inward from the end of the frame.
FIG. 2-8
150210-3
Turn crank clockwise to
lower saw head;
counterclockwise
to raise saw head
Lock Release
Pointer