Wacker Neuson ET12 02, Руководство оператора

Страница: 152 / 286

5-48
BA ET18, 20, 24 en* 1.5 * et18_20_24b510.fm
5 Operation
Retrofitting a bucket
Removing
1. Lower the bucket to level ground with the flat side facing downward.
2. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
3. Remove linch pins A .
4. First remove the bolt B , then bolt C ; carefully drive out seized bolts with
a breaker and brass punch.
If pin C is stuck:
1. Start the engine.
2. Slighty raise and lower the boom to take the load off the pin.
3. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
4. Raise the control lever base.
5. Remove the starting key and carry it with you.
Information
Place the bucket only with minimum pressure on the ground as you
remove the pins. The higher the pressure on the ground, the higher the
resistance and the more difficult it is to remove the pins.
Mount
1. Install a bucket only if it is positioned on level ground with the flat side
facing downward.
2. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
3. Apply grease to the pins and joints before inserting the pins.
4. Start the engine.
5. Straighten the stick so that bores
D and E are flush.
6. Stop the engine. Raise the control lever base.
7. Insert pin
F .
8. Actuate the stick cylinder until bores H and I are flush.
9. Stop the engine. Raise the control lever base.
10.Insert pin
J .
Install linch pins K .
Fig. 198Removing
A
C
B
Fig. 199Mount
D
K
F
E
H
I
J
K