VWR MD 8000 L, Руководство по эксплуатации

Страница: 88 / 98

Firmware update MD 8000 L
88
ba77218e01 11/2018
16 Firmware update
16.1 Firmware update for the meter MD 8000 L
With the "Firmware Update " program and a PC you can update the firmware
of the MD 8000 L to the newest version.
For firmware updates for the meter, go to www.vwr.com , or contact your VWR
sales center.
For the update you have to connect the meter to a PC.
For the update via the USB-B interface, the following is required:
 a free USB interface (virtual COM port) on the PC
 the driver for the USB interface (on the enclosed CD-ROM)
 the USB cable (included in the scope of delivery of the MD 8000 L).
After switching the meter off and on you can check whether the meter has taken
over the new software version (see Y
OU WANT TO KNOW WHICH SOFTWARE
VERSION IS IN THE METER OR
IDP
SENSOR
,
PAGE
87).
1. Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the meter (or meter type), the new
data are displayed there.
2. In the windows start menu, open the update folder and start the firm-
ware update program for the meter
3. Using the USB interface cable, connect the MD 8000 L to a USB inter-
face (virtual COM port) of the PC.
4. Switch on the MD 8000 L.
5. In the firmware update program, start the update process with OK.
6. Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes up to 15 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firm-
ware update is completed.
7. Disconnect the MD 8000 L from the PC.
The MD 8000 L is ready for operation again.