VWR MD 8000 L, Руководство по эксплуатации

Страница: 66 / 98

Settings MD 8000 L
66
ba77218e01 11/2018
11.3.2 Enter cap coefficients
11.3.3 Saturation, local
Irrespective of the height or air pressure, the calibration value is set to 100 %.
The function
Saturation, local fulfills the EU regulations for the parameter
oxygen saturation [%].
When the Saturation, local is enabled the display shows an [L] for the param-
eter oxygen saturation.
D.O. mg/L readings are unaffected by the selection of the Saturation, local
function.
11.4 Cond measurement settings
11.4.1 Settings for IDP conductivity sensors
Settings The settings are made in the menu for the measured parameter, conductivity.
To open the settings, display the required measured parameter in the mea-
sured value display and press the
<OK>
key. After completing the settings,
Saturation, local on
off Saturation, local is a procedure that
takes the local air pressure into
account for each saturation mea-
surement.
For details, see section 11.3.3 S
AT
-
URATION
,
LOCAL
, page 66.
Reset - Resets all sensor settings to the
delivery condition (see section
11.7.1 R
ESETTING THE MEASURE
-
MENT SETTINGS
, page 71).
The values of the coefficients are provided with the sensor cap.
1. Change the digit of the highlighted position with
<

><

>

.
2. Go to the next position with
<

><

>
.
3. Confirm with

<OK>
when a coefficient is completely entered.
Menu item Possible
setting Explanation