Volvo SDLG LG956L, Руководство по эксплуатации и техническому обслуживанию

Страница: 45 / 130

Operation & Maintenance Manual ── LG956L Wheel Loader
40
z Do not let water enter an electric part (such as sensor, wire connector) or operator cab. If so, the
operation may be disabled and the electric circuit may be damaged.
z Wear protect clothes and glasses when using compressed air to clean the filter mesh.
8.9 Heavy Materials
z Wear protect clothes, safety glasses and safety helmet and put a copper bar between the hammer
and the part being hit.
z Eyes may be damaged by flying hard particles, such as pin and bearing when hit by a hammer.
z Use tools and heavy materials carefully. Prevent them falling down.
8.10 Welding Repair
Electric welding requires a special technique, proper equipment and place. No person is allowed to
weld without a license. Escaped gas and damaged electric wires are potential problems during
welding. Obey the following:
z Switch off the electricity in the terminals for storage to prevent explosion.
z Clean the paint at the welding site to prevent the production of harmful gas.
z Avoid welding on the hydraulic equipment or pipe, or places nearby. Flammable steam and
sparks may be generated.
z Cover the rubber, wire or pressure pipe and use
anti-fire plate during welding because a spark may
cause a sudden crack or shatter the insulating tape.
z Be careful when welding near tires, which may cause
a thermal explosion.
z Wear protective clothes during welding.
z Keep the welding area ventilated.
z Clean up the flammable materials and check the fire extinguisher.
z Never do any modifications which may affect the performance, safety and strength capability of
the vehicle and the working equipment.