Remove:
the 3 screws
the control module.
INSTALLATION
INSTALLING THE DAMPER MOTOR MODULE (DMM) FOR TEMPERATURE
Install:
the control module in position. Adjust the shaft journal so that it goes in
the 3 screws. Tighten crosswise
the switch
the dashboard. See:
DASHBOARD
FINISHING
TESTING THE CLIMATE CONTROL SYSTEM
Carry out a performance test on the climate control unit. See:
CLIMATE CONTROL SYSTEM, CHECK
.
ACTUATOR, MIXER DAMPER
PREPARATORY WORK
IMPORTANT INFORMATION
The damper motor module (DMM) for air distribution is only on the left-hand side.
REMOVING THE DASHBOARD
Remove the dashboard. See:
DASHBOARD
REMOVAL
REMOVING THE DAMPER MOTOR MODULE (DMM) FOR AIR DISTRIBUTION
NOTE:
Identify the damper motor module (DMM) temperature. See VIDA (Volvo scan
tool) Vehicle communication.
NOTE:
The illustrations in this service information are used for different model years
and/or models. Some variation may occur. However, the essential information in
the illustrations is always correct.
2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation