Fig. 240: Identifying Clips And Screws
Courtesy of VOLVO CARS CORPORATION
Secure the bumper casing with the clips (1) and screws (2).
Fig. 241: Pulling Up High-Pressure Nozzle From Bumper Casing
Courtesy of VOLVO CARS CORPORATION
Pull up the high-pressure nozzle from the bumper casing and install the covers on both sides.
Connect the cable for the engine heater, if applicable. Route and clamp it in the same way as it was
installed before. Replace cut cable ties with new ones.
Remount the front wheel and tighten the wheel bolts to
90 Nm (66 lbf. ft.)
.
NOTE:
Do not clamp the cable directly to AC pipes, fuel lines, brake pipes or
power steering hoses and pipes. Make sure the cable does not chafe
against sharp edges or moving parts in the engine compartment.
2012 Volvo C30 T-5
ACCESSORIES AND EQUIPMENT Bumpers And Mudflaps - Installation Instructions, Accessories