VITALI FLARES, Техническое руководство, Страница: 64 / 88

T 5
60
D
C A F
B
C
A
E
B
D
G
H
I
Male connector
side
Female connector
side
Replacing the backrest actuator
Remove the upholstery as described in the chapter " Accessing the internal parts ", par. " Removing the seat
upholstery " and the seat housing as described in the chapter " Accessing the internal parts ", par. " Removing
the seat housing ":
IF THE ACTUATOR DOES NOT WORK:
1) Unscrew the dowel/activator " A ".
2) Remove the Seeger ring " H " and the pin " F ", raise
the seat as indicated by the arrow " I " to make the
M5 hole in the pin " C " accessible.
3) Cut off the electrical power supply.
4) Use an extractor screwed into the M5 hole in the
pin " C " to remove the pin itself.
5) Cut the cable " G " and replace the actuator,
applying the connector supplied.
6) Replace the pins " C " and " F ", the dowel/activator
" A " and the Seeger ring " H ".
7) Turn on the electrical power supply.
8) Activate the backrest to make sure that the backrest
limit switches are working properly.
IF THE ACTUATOR WORKS:
1) Unscrew the dowel/activator " A "
2) Activate it using the foot control or keypad in the
direction shown by the arrow " E ", to make the M5
hole in the pin " C " accessible.
3) Cut off the electrical power supply.
4) Use an extractor screwed into the M5 hole in the
pin " C " to remove the pin itself.
5) Remove the stop (Seeger) ring " H " from the pin " F "
and then remove the pin
6) Cut the cable " G " and replace the actuator,
applying the connector supplied.
7) Replace the pins " C " and " F ", the dowel/activator
" A " and the Seeger ring " H "
8) Turn on the electrical power supply
9) Activate the backrest to make sure that the backrest
limit switches are working properly.
Specific tools required: M5 screw extractor