VITALI FLARES, Техническое руководство, Страница: 12 / 88

T 5
8
F
B
A
D
E
G
C
7 INSTALLATION INSTRUCTIONS
☞
NOTE: For more details on removing the housing " F " and the seat upholstery, see the chapter on " Accessing
the internal parts - Flares ".
PLEASE FOLLOW THE INSTRUCTIONS BELOW CAREFULLY
FOR INSTALLING THE FLARES CHAIR!
To avoid breaking the plastic housing, please use the special keys " A " and " B " supplied with the chair.
Use them as follows:
1) Power the chair at 230 V AC - 50/60 Hz - single-phase
WARNING!
The power supply cable should be directly connected to the electrical installation:
DO NOT make use of extension cables.
Each equipment have to be individually connected to a socket
through the provided plug, without using multiple outlets.
2) Press the main switch " C "
3) To raise the chair, use the foot control (if present) or dentist keypad, after connecting it to the connector CN20
of the chair card. In this case, see the chapter on
"Setting the Chair Movement Dip-switches"
4) Remove the grey polyurethane cover " G " and tighten the key " A "
5) Remove the upholstery from the seat, pulling on points " D " and " E "
6) Remove the housing " F ", after first turning the mobile part of the seat (see the chapter on "Accessing the
internal parts - Flares" )
7) Tighten the key " B " in the point shown in the illustration
8) Move the chair by lifting it with the keys " A " and " B "
9) Remove the keys " A " and " B ".