Vishay G4-DT, Техническое руководство, Страница: 166 / 174

Technical Manual
-2
Force errors
The indication is either temporary or stays on until the cause is cured.
Error
code Explanation
000 No error.
The instrument is in ‘normal state’ and no error is detected.
x003 Instrument not in normal state.
Force/Web Tension values are not valid.
x005 Over range
Over range means that the input signal from the transducer exceeds
the operating range.
x007 Under range
Under range means that the input signal from the transducer is below
the operation range.
x010 Exicitation short-circuit
Either a short-circuit in the excitation circuit or too many transducers
connected. (A fault in a transducer or inside the instrument is also possible.)
Check transducer connections. See chapter, 2 Installation.
x011 Sense voltage error
The sense voltage is out of range. Check transducer connections. See chapter,
2 Installation.
x012 Transducer signal error
The input signal is out of range, for example due to a faulty or missing transducer
connection. (A fault in a transducer or inside the instrument is also possible.)
Check transducer connections. See chapter, 2 Installation.
x014 Invalid input signal
Invalid input signal is reported while the instrument is waiting for sufficient
conversion data to calculate a valid force value. This indication is reported during
power-up since input value might be momentarily unreliable.
x020,
x191 Too many digits
The actual value with the configured number of decimals is exceeding 6 digits.
The ‘x’ in the error code may be omitted (blank) or a digit (1-4). A digit indicates that the
error comes from a certain Function Block input. The digit ‘1’ corresponds to Function
Block Input A, the digit ‘2’’ to input B etc.