Virginia Controls, LLC
MH-3000 User Manual, 1_03C10-VC
Page 96
target for the floor below. With Floor Switches or a Pulsing Selector, if the slowdown
overlaps the leveling zone of the adjacent floor, then special short floor circuitry is
required, and this setting will not normally apply. (Check for specific instructions for the
job.)
•
Enable Homing
- (Display shows "ENABLE HOMING" on Simplex, or "HOME #2 TO
MAIN" on Duplex) Enable this feature to enable the homing feature on a Simplex. This
will cause the car to home to the Home Landing, when it has been idle for the adjustable
Homing delay time.
NOTE: On a Duplex, one car will always home to the Dispatch Main Landing,
and, if this feature is set, then the FREE car will also home to the Dispatch
Main Landing.
•
Enable Free Car Homing
(Duplex Only) - (Display shows "HOME TO HI ZONE") Enable
this feature to home the free car to the Upper Home Landing. If this is not set, then the
car will remain where it last stopped.
•
Enable Homing to Dispatch Landing
(Group Car Controllers Only) - (Display shows
"HOME TO DISP.LDG") Enable this feature to force this car to home to the Dispatch
Landing.
•
Enable Homing to Alternate Home Landing
(Group Car Controllers Only) - (Display
shows "HOME TO ALT.HOME") Enable this feature to force this car to home to the
Alternate Home Landing.
•
Home All Cars to the Dispatch Landing
(Group Dispatcher Only) - (Display shows
"HOME ALL TO MAIN") Enable this feature to home all cars to the Dispatch Landing.
Some installations require specific settings or features that are not included in the
standard program. In this case, a separate sheet (or sheets) will be provided that describe
the operation of these settings or features, and what the factory default settings are.
Normally, special features are included in the Bit Features settings, not under the Features.
6.2.7
Show Fault Log
This selection is the same as the Show Fault Log in the Run Mode section. The screen
shows the fault log, which consists of the last 63 faults and events recorded by the
controller. The controller will not log faults in the Setup Mode, but existing faults can be
viewed.
Refer to the descriptions in the Show Fault Log section in the Run Mode for a full
description of the operation when viewing this screen, and for a description of the fault
codes displayed.
6.2.8
Show Internal Memory
This selection is the same as the Show Internal Memory in the Run Mode section. The
screen shows the contents of the internal memory. This can be used to check the status of
internal registers, to show the operation of the system. Keep in mind that in the Setup
Mode, the car is stopped, and all Inputs and Outputs are off.
If the password has not been entered in another screen, then when this screen is
selected, the “Password
Entry” screen will be displayed. If the password (“911”) is
entered
correctly, then the internal memory can be changed. If it is not entered correctly, then the
memory can still be viewed, but cannot be changed.