Virginia Controls, LLC
MH-3000 User Manual, 1_03C10-VC
Page 77
Press the Nxt or Prv keys to move through the Set-up Menu to the desired item, then
press Ent to select the menu item.
6.2.4
Reset Settings
This selection allows all settings and features to be reset to the factory values that are
stored in the EPROM. This should be done on initial installation, and is recommended if the
operation of the car seems strange. (See the warning below.)
Press Ent to reset all settings and features to the values programmed from the factory.
After pressing Ent the password entry screen will be shown. This prevents accidentally
resetting the default values. The password must be entered each time the Reset Settings is
attempted. Enter the password “911” then press
Ent to reset all settings and features to
the factory default. Press Esc to exit without resetting the settings and features. If the job
is a standard job, then the specific settings and features for your job must be entered after
doing a factory reset. (See the warning note below)
Press Nxt or Prv to move to another item in the Set-up Menu.
Press Esc to return to the Run Mode.
To RESET SETTINGS, (see above)
To CHANGE SETTINGS, (see below)
Virginia Controls
MAIN SETUP MENU
Press ENTER to
RESET SETTINGS
Press ENTER to
CHANGE SETTINGS
Press ENTER to
CHANGE FEATURES
Press ENTER to
SHOW FAULT LOG
Press ENTER to
ENTER PASSWORD
Press ENTER to
TEST I/O BOARD
WARNING
:
IN SETUP MODE,
THE CAR IS SHUT DOWN.
SETUP MODE SCREENS
ALL SETTINGS
HAVE BEEN RESET
WARNING: TEST
ACTIVATES RELAYS
ENTER PASSWORD
01 09:40 FLTCODE
2 1100 0011 0010
(Display and Change
Adjustable Features)
(Display and Change
Adjustable Settings)
= Press “Prv”
= Press “Nxt”
= Press “Ent”
= Press “Esc”
The normal sequence is to press “Nxt”
to select the desired menu item.
Press “Ent” to use the menu item.
Press “Esc” when you are finished.
To Run Mode,
Car Status Screen
Press ENTER to
SET THE TIME
(Enter the Time
and Date)
Press ENTER to
SHOW INT MEMORY
0400 00 00 00 00
0404 00 00 00 00
