Vibra CJ-E series, Руководство по эксплуатации

Страница: 92 / 112

Troubleshooting
-78-
7-1 Error Messages
Message Cause Remedy

- The weight of the sample is over the
weighing capacity
- The number of digits in the addition result
or calculation result went over the number
that can be displayed.
- Unload the sample to weigh it in
some portioned-out measurements.
- Replace the tare with a lighter one.
- If the error message does not
disappear even when nothing is
placed on the pan, mechanical parts
may have failed. Contact our Sales
Office or Technical Service Division.
- First, clear the addition result. Then
execute addition again.
- The coefficient used in unit
converting is too small. Set a greater
coefficient.

The minus-value load exceeded the lower
limit.
- The pan or the pan base may not be
properly set. Check them, paying
attention to whether they are in
contact with an external object.
- If the error message does not
disappear even if the pan and the pan
base are properly set, mechanical
parts may have failed. Contact our
Sales Office or Technical Service
Division.

The reference weight used during span
adjustment with an external weight is far
less than 50% of the weighing capacity.
For span adjustment with an external
weight, use a weight that weighs as
close to the weighing capacity as
possible.

An error over 1.0% was detected in span
adjustment with an external weight, or the
balance failed.
For span adjustment with an external
weight, check that a correct weight is
placed and that no objects other than
the weight are placed. Then, execute
span adjustment again.