Chapter 4 — Maintenance and Repair
157
Fuse Replacement
The removal and replacement procedure for the primary and secondary power
supplies is as follows. Please observe all electrical safety procedures while per-
forming the replacement. Replacement should be done by qualified personnel.
1. Power down the CineCast HD decoder and remove the plastic front panel
cover by gripping the sides and pulling the cover straight out.
2. Remove four access screws for the primary power supply tray.
3. Slide out the power supply tray approximately 3".
4. Detach any cables that may be attached to the supply.
5. Completely remove the defective power supply assembly by sliding it the rest
of the way out of the unit.
6. Install the new primary power supply assembly. Installation procedure is the
reverse of the removal procedure.
Fuse Replacement
For equipment protection, the Vela CineCast HD/1 and HD/2 incorporate a pair of
2A Slo-Blo line fuses that are located within the AC power receptacle. The fuse
replacement procedure is as follows:
1. Power down the unit by depressing the power switch.
2. Disconnect the AC power cable from the rear of the unit.
3. Remove the fuse container (located directly above the AC receptacle).
4. Replace the defective fuse(s) with 2A 250V Slo-Blo fuses as needed.
5. Reinstall the fuse container, reconnect the AC power cable, and apply power to
the unit. Note that if a customer-supplied power cable is used, it must be equal to
or exceed 18 AWG, 1250W, 10A-125V.
Содержание 2000-0600
