Vela 2000-0600, Инструкция по установке и эксплуатации

Страница: 123 / 179

Chapter 2 — Decoder Command Set Guide 113
SCSI Command Error Conditions
BUSY SCSI Status may be returned if decoder has not entirely finished executing
the last decoder command. (Retry command.)
When genlock is enabled [via
DECODER
(45h) command, command code 0016h],
and the genlock request is not present (bit 15 of command = 0):
Additional Sense Bytes (bytes 18 & 19) will be set to 0107h. The MPEG PLAY
command in this genlock mode is not executed.
When “Soft Error Mode” and genlock is not present at Play command, the follow-
ing error is returned (bit 15 of command = 1): “Recovered error, genlock sync lost.”
WRITE BUFFER
“Illegal request, invalid field within CDB.” A reserved or specific field contains
invalid data.
“Illegal request, logical block address out of range.” Address or transfer length is
outside the range of the microcode memory.
SCSI Status Check Condition
Sense Key 05h
Additional Sense Code and Qualifier 6100h
SCSI Status Check Condition
Sense Key 01H
Additional Sense Code and Qualifier 6100h
Additional Sense Bytes 18 & 19 0107h
SCSI Status Check Condition
Sense Key 5h
Additional Sense Code and Qualifier 2400h
SCSI Status Check Condition
Sense Key 5h
Additional Sense Code and Qualifier 2100h