Vela 2000-0600, Инструкция по установке и эксплуатации

Страница: 20 / 179

10 CineCast HD Version 2.6 Installation and User Manual
Decoder Installation
Decoder Installation
HD Board Only Installation
1. Power off the PC, unplug it from the AC source, and remove the cover to
expose the chassis and motherboard.
2. It is important that the CineCast HD decoder board be plugged into a PCI bus
master slot, making sure the edge connectors are fully engaged. Secure the board’s
mounting bracket to the PC chassis.
3. Connect video, audio, genlock, and SCSI cables as required.
4. Set the SCSI ID switch to the correct ID. Set the SCSI terminator switch to the
down position to disable the internal SCSI terminators, if required.
5. Reinstall the PC cover and power up normally.
Models HD/1 and HD/2 Rack-Mount Decoders
1. Install the decoder unit in a suitable 19-inch equipment rack, insuring that
adequate ventilation is available.
2. Connect video, audio, and SCSI cables as required.
3. Set the SCSI ID switch to the correct ID. Set the SCSI terminator switch to the
down position to disable the internal SCSI terminators.
4. Assure that the AC power switch on the front panel is off, then connect the
AC power cable from the receptacle on the rear of the unit to a suitable AC
outlet. Note that if a customer-supplied power cable is used, it must be equal to
or exceed 18 AWG, 1250W, 10A-125V.
5. Power-up the unit by depressing the power switch.
6. The play indicator(s) and the power indicator on the front panel should begin
blinking, indicating normal operation.
29. Firmware Download Mode
30. LTC Output Reporting
Item Functions/Commands
Table 1-1. CineCast HD Functions Summary